Your utility bills drop the first month. Not by a little—by enough that you’ll notice. Heat pumps use up to four times less energy than electric resistance heating, which means real savings every time your system runs.
You stop worrying about whether your heating will hold up during cold snaps. Texas winters are mild, but when temperatures drop, you need a system that works. Heat pumps handle China Grove’s climate without the stress of juggling two separate systems for heating and cooling.
Your home stays consistently comfortable. No more hot spots in summer or cold rooms in winter. A properly sized and installed heat pump system delivers even temperatures throughout your house, and you control it all from one thermostat. That’s what you’re paying for—comfort you don’t have to think about.
We’ve been installing and servicing HVAC systems in the San Antonio area since the early 1990s. We’re veteran-owned, locally operated, and we’ve seen just about every heat pump scenario you can imagine.
China Grove homeowners have different needs than folks in bigger cities. You’ve got larger properties, older homes that need careful sizing, and you expect contractors to show up prepared. We carry the parts and equipment needed to complete most heat pump installations on the first visit.
Our certified technicians don’t cut corners on installation. We size your system correctly, test airflow, check refrigerant levels, and make sure your new heat pump runs at peak efficiency from day one. You’re not getting a rushed job—you’re getting it done right.
First, we assess your home. That means measuring square footage, checking insulation, evaluating your existing ductwork, and calculating the right size heat pump for your space. Undersized systems run constantly and wear out fast. Oversized systems cycle on and off too much and waste energy. We get the sizing right.
Next, we remove your old system if you’re replacing one. We disconnect everything safely, remove the old equipment, and prep the space for your new heat pump. If your ductwork needs repairs or sealing, we handle that before installation.
Then we install your new heat pump system. We mount the outdoor unit on a level pad, connect refrigerant lines, wire the indoor air handler, and integrate everything with your thermostat. After installation, we test the entire system—airflow, refrigerant charge, electrical connections, and temperature output. You don’t pay until we verify everything works correctly.
We walk you through operating your new system before we leave. You’ll know how to adjust settings, when to change filters, and what to watch for. Most importantly, you’ll have our number for 24/7 emergency service if anything comes up.
Ready to get started?
You get a complete system evaluation before we install anything. We’re not just swapping units—we’re making sure your home can support efficient heat pump operation. That includes ductwork inspection, insulation assessment, and electrical system verification.
Your installation includes proper refrigerant charging, which most homeowners don’t think about but makes a huge difference. Incorrect refrigerant levels can reduce efficiency by 20% or more. We charge systems to manufacturer specifications and test performance under load.
China Grove’s median household income sits around $103,000, and nearly 90% of residents own their homes. You’re making a significant investment in your property, and you need installation done right the first time. We include manufacturer warranty registration, system testing documentation, and a maintenance schedule customized for Texas climate conditions.
You also get access to our 24/7 emergency service. Heat pumps are reliable, but if something goes wrong at 2 AM on a Sunday, you can reach us. We’ve been serving Bexar County for over 30 years because we show up when homeowners need us.
Heat pump installation in China Grove typically runs between $4,300 and $12,000 depending on system size, efficiency rating, and whether you need ductwork modifications. Most homeowners in the area pay around $6,400 for a complete installation, which is slightly above the national average.
The price depends on your home’s square footage and your existing HVAC setup. If you’re replacing an old heat pump and your ducts are in good shape, you’re looking at the lower end. If you need new ductwork, electrical upgrades, or you’re installing in a larger home, expect higher costs.
Don’t shop on price alone. A cheap installation with an undersized system or poor ductwork connections will cost you more in energy bills and repairs over time. You want proper sizing, quality installation, and a contractor who’ll be around to service the system. That’s what you’re actually paying for.
Yes. Modern heat pumps handle Texas winters without issues, even during occasional freezes. China Grove rarely sees extended periods below 32°F, which means heat pumps operate efficiently throughout winter.
Heat pumps work by extracting heat from outdoor air and moving it inside. They can pull heat from air temperatures as low as 5°F, though efficiency drops as temperatures fall. Since China Grove’s average winter lows stay in the 40s, your heat pump runs at high efficiency most of the season.
If you’re worried about extreme cold events like the 2021 freeze, many homeowners add a backup heating source. But for typical Texas winters, a properly sized heat pump keeps your home comfortable without supplemental heat. We’ve installed hundreds of heat pump systems in the San Antonio area, and they perform well in our climate.
Most China Grove homeowners see 30-40% reductions in heating and cooling costs after switching to a heat pump. Your actual savings depend on what you’re replacing and how you use your system.
If you’re currently heating with electric resistance coils, your savings will be significant. Those systems average about 9 kW of peak demand and cost roughly twice as much to operate as heat pumps. If you’re replacing an old, inefficient AC and furnace combo, you’ll still see noticeable savings, just not as dramatic.
Heat pumps provide up to four times more heat energy than the electrical energy they consume. That efficiency translates directly to lower utility bills. On a $200 monthly energy bill, a 35% reduction saves you $70 per month, or $840 per year. Over a 15-year lifespan, that’s $12,600 in savings—more than enough to cover your installation cost.
Most heat pump installations take one full day, typically 6-8 hours. Straightforward replacements where we’re swapping an old heat pump for a new one can sometimes finish faster. Complex installations with ductwork modifications or electrical upgrades might extend into a second day.
The timeline depends on your specific situation. If we’re replacing an existing system and your ducts are in good condition, we can remove the old equipment, install the new heat pump, test everything, and have you up and running in a single visit. That’s why we bring all necessary parts and equipment on the first trip.
If you need ductwork repairs, new electrical circuits, or significant modifications to accommodate a different system size, plan for additional time. We’ll give you an accurate timeline after evaluating your home. What matters is that we don’t rush the job—proper installation affects your system’s efficiency and lifespan for the next 15+ years.
Not always, but we need to inspect it first. If your existing ductwork is properly sized, sealed, and in good condition, you can usually keep it. If it’s leaking, undersized, or poorly designed, repairs or replacement make sense.
Leaky ducts waste 20-30% of conditioned air before it reaches your rooms. That means you’re paying to heat and cool your attic or crawlspace instead of your living space. We test duct systems for leaks and airflow restrictions during our initial assessment. Minor leaks can be sealed. Major problems need more extensive repairs.
Duct sizing matters too. If your new heat pump moves more air than your old system, undersized ducts create pressure problems and reduce efficiency. We calculate required airflow based on your new system’s capacity and verify your ducts can handle it. Sometimes that means adding return vents or enlarging certain duct runs. We’ll tell you exactly what your ductwork needs before we start the installation.
Texas doesn’t have a statewide heat pump rebate program, and federal tax credits expired at the end of 2025. However, some local utilities offer rebates ranging from $100 to $3,000 depending on your provider and system efficiency.
CPS Energy, which serves the San Antonio area including China Grove, offers rebates through their Casa Verde program. You can receive $100-$275 per ton of cooling capacity for qualifying high-efficiency heat pumps. Oncor’s Take a Load Off Texas program offers up to $600 per unit for qualifying systems.
Rebate programs change frequently, and eligibility requirements vary. Some require specific efficiency ratings or pre-approval before installation. We stay current on available rebates and can help you navigate the application process. Even without rebates, the energy savings from a properly installed heat pump typically pay for the system within 10-15 years.
Local Resources
Other Services we provide in China Grove
Call Now
